Quote from: Jack 1000;57754What happens when you just hook up the DVR to the TV and leave the receiver out of the picture? If that works OK, than it might be an issue with the receiver and the DVR.
If that doesn't work, check audio settings on the DVR and receiver to see if anything was accidentally changed. TWC sometimes pushes software updates without warning, so a setting on the DVR/reviver might have been changed.
If that doesn't work, I would turn off the TV, DVR, and receiver and than unplug each one for about five minutes. After plugging in each one, power up each one. Wait for the box to boot up and for the time to display on the box for 30 seconds, before turning the TV back on. Now see if that solves the problem. I will refer this issue to my cable engineering contact if it does not and see what he says.
Jack
OK,
I have not tried the sound on the TV itself to see if that's effected.
The first thing I did was check the audio settings on the DVR. Those were unchanged.
Changing the A/V receiver to 2 channel output works fine. DD not so much.
I have not done a cold boot on the DVR or receiver yet. I'll have to try that after work tonight.
I'll let you know what happens.
Thanks Jack.